Tried to check out my new '23 in AlfaOBD last night and ran into some issues. Running the latest version 2.3.7.0. The website says 2.3.6.0, but that isn't what downloads. I was going to try to go back to a previous version, but I couldn't find one, and I apparently deleted my slightly older installer.
@Jimmy07 (or anyone else) any ideas?
Edit to add: I tried Scan from my iPhone, and I don't have a license so I can't make any changes, but it had no problem reading anything from the truck. This makes me think the AlfaOBD version may be a part (if not all) of the problem.
- Not unexpectedly it doesn't show 2023 yet, so I selected 2022 since I figured it should be nearly the same.
- Trying to do a "Read System ID" doesn't do anything except add a timestamp to the log.
- In the "Active Diagnostic" section (where "Car Configuration Change" is) it seems to want to run everything just by scrolling past it. Moving the mouse down the list I crossed over "Reset ECU" and the truck's systems all restarted as if I'd clicked on it and hit "Start". The message box also continuously says "Failed. Requested procedure is no supported by the unit."
- If I attempt to actually make a configuration change (I really want the TPMS down from 65/70 F/R) it doesn't work.
@Jimmy07 (or anyone else) any ideas?
Edit to add: I tried Scan from my iPhone, and I don't have a license so I can't make any changes, but it had no problem reading anything from the truck. This makes me think the AlfaOBD version may be a part (if not all) of the problem.