Recent content by Steevo

Thanks for all the pics. Ordering today!!

I only found two on Youtube. Neither showed a low-angle shot of the installed protector.

Thanks!!

Has anyone here bought/installed the Geno's Garage "Splash Wham-o" tailgate protector? I am looking at buying one, but was hoping to see some better pictures of one installed on a tailgate. The pics on Geno's site are from too high an angle to see how far down the outside part goes under the...

Yeah, and their Price match guarantee is complete BS!

After several trips with my Titan 52 gal. tank, I can say I am happy with it. Just got back from a trip to Calif from my home in Idaho, and it sure is sweet to never have to think about a fuel stop and only stop when and where you want to. I do have some feedback for anyone using the Titan 52...

When I had my Titan 52-gal tank installed at the Titan facility, they filmed the installation to make a "how-to" video of the removal/installation process. I just got the link yesterday to their finished video.

After several tanks of fuel, my experience is totally positive with my Titan 52 gallon tank. I have run it down to as low as I dared, and not had the low fuel warning come on. The lowest "miles to empty" I have run it down to is 54. With the original tank, it would come on when I had about 5~6...

Brandon, the tech at Titan told me all they set is the capacity (197 liters), and the computer adjusts the rest. He said you do go a long ways (about 10 gallons) before the gauge comes off of full, because there is a fair amount of fuel above the top of where the stock float reaches, but as the...

Just had my 52 gal. Titan tank installed today. Since I live in Idaho Falls, where Titan's HQ is, I had them do the install at their facility. What a great bunch of people they are! My thanks and appreciation to Mitch, Brandon, and the entire crew at Titan for their hospitality, friendliness...

I don't like it. It is too "thumpy" for my taste. I can't turn the bass down enough to make it tolerable. I think they should have had a separate control for the subwoofer, to allow cranking it down separately from the equalizer.

No weirdness from the radio/speakers after removing it?

So, a DP switch that re-routed the current back through a resistor would simulate a load for the PCM module, but then the module thinks it is heating the cushion but senses no heat, sending the PCM brain into an endless feedback loop until it decides the cushion is bad and shuts it down...

Thanks for the great information, I appreciate it. This is sounding more complicated than I hoped it might be.

My 2020 3500 CCSB has the heated/ventilated seat in front. I would like to install a small switch in the side panel of the drivers seat to allow me to turn the seat bottom heat off/on so that I could run lumbar heat without butt heat. Does anyone here know what wires in the under-seat space...