Compliments of Jimmy07 for my 2020 2500
Doors: Blindspot Mirror Present- YES
CustSetMenu 1: Blind Spot Alert CSM Present- YES
CustSetMenu 3: Trailer Length Blindspot Enable/Disable CSM Present- YES
Cabin Net: RBSM Right Blind Spot Module- ENABLE
Cabin Net: BSS Blind SpotSensor/LBSS Left Blind Spot Sensor- ENABLE
After what seems like months of working on this I finally got to this part. I have the kaodtech bypass, the OBDlink MX and an Android phone with the AlfaOBD software and to my surprise everything connected and I selected my truck (Ram 2500) and got started.
I never saw anything on the menu that asked me if I had a blind spot mirror or Blind Spot Alert CSM Present or Trailer Length BS Enable/Disable CSM Present.
Here is what I did after I was connected and was on the ‘My car‘ page after selecting Dodge Ram.
I navigated to Ram 2500 (DJ/DR)
Selected Driver Door
Select Control Unit (I selected Driver Door Module MY-2012)
Then it asked me to Connect (which it did) and then I selected ENABLE which it said it had done. My other choice was to DISABLE.
The only other item on the My Interface menu that looked like I should visit was ‘Object Detection’ which led me to ‘Select Control Unit’ and then I selected ‘Left Blind Spot Sensor (LBSS)’. I successfully connected and then opted to run some type of test which said was a success. Made some beeping sounds in the truck. I did the same thing for the right side and said it wasn’t successful. I’m not sure what happened with that. It didn’t give me any information other than it wasn’t successful even though it was connected.
I went for a drive and hit every four lane road I could find. Not once did the BSM light go on or did I hear a beep. Obviously I’ve done something incorrectly.
I have a 2021 so I’m not sure something has changed and I missed a step. All of the information I’ve seen for the AlphaOBD is for 2020 trucks and prior years. Anyone have any thoughts or ideas?
Thanks.