Recent content by Dirtbiker70X

Did you replace the clock spring yourself or did you take it into the shop? My heated wheel is acting up as well and truck is out of warranty so am considering tackling the job myself.

My truck just started exhibiting this same behavior. The truck is 2 months out of warranty @RamCares can you help?

Hi Guys, 2020 Ram 3500, H.O./Aisin - Was coming home pulling my 5th wheel on Thursday, truck dinged at me a few times and dash lit up like a Christmas tree. Info center says "Stability Control needs Service" and "ABS needs service". Pulled the codes mentioned in the title. ABS, ASC, C.C. all...

Thanks for the info!!

Thanks for your input! I suspect the same and will post if we find otherwise.

Mine was completed the last week of November. I have not noticed excessive regens and the MIL has not been on. The truck does seem to be noisier on part throttle (alot more diesel rattle) but seems to run well and pulled the trailer fine from Missoula down to Colorado Springs last month. No...

Hello Gang! A buddy of mine backed into a tree with his tailgate down, damn tree jumped out of nowhere, taco'd it nicely and beyond repair! He's got a 2020 2500, Delmonico red. Does anyone know if there any interchangeability between the 4th gens and the 4.5? (or perhaps a 5th gen 1500?)...

I have not had any recurrence of the code after I cleared it.

Mine has dual alternators and Lane Sense both of which they had never seen on a truck. Not to mention, it took them FOUR DAYS!!!

Mine was low on coolant. (I could see witness marks where they had disconnected the upper hose at the radiator. )

Good point! I won't worry about it!

Hello All, So, I fired up my AlfaOBD after work today and was poking around trying to figure out how to disable ANC. There was a saved P026B Injection Timing Performance code that was not there when I checked codes after I picked the truck up after having the recall done. Check engine light was...

I added a Morryde 5-foot slide-out tray to my basement storage, had to move the basement wall and make the insert that is raw plywood (I covered it with speaker carpet later) in the picture. Then cut the legs off of my tool cart and bolted it to the tray. Makes for a handy workstation when...

Yep, it's a 397. Of course, the generator exhaust and underbelly hang even lower than the frame rails, I've been meaning to get under there and give her a tummy tuck! There have been a couple of occasions where I was just cringing waiting for something to hit or drag, couldn't have been more...

I am running with 5 - 5 1/2 inches of bed clearance, I couldn't get more than that keeping the trailer level. I am a full-time RV'r and have not had any issues in the past 2 1/2 years. Now, my real limiting factor is really the trailer. It has a drop frame so there is not a lot of clearance...