Im using a VoSwitch 8 gang for a Jeep JK i got off of Amazon. modified the JK bracket and bolted off of the fender in front of the TIPM.Which light switch are you using to run your lights?
Went with 4 cause they’re sold in pairs@Chris85xlt and @Cycleman4
And specific reason you went with 4 lights vice 5?
How much clearance between the grill and the back of the light?
I've been looking at the Rigid Adapt XP Extreme lights. Was thinking 3 adapt lights in the center, set up in adapt mode. Then 2 adapt lights on the ends, set up mainly in wide beam mode, pointed slightly out.
Looks like they would fit as they are 6" lights. They may stand out at little more as they are 3.65" deep. But the mounting bracket is towards the rear of the light.
They are 9384 lumens vs 7260
Any chance you could get a shot of the screen with the front camera/surround view on? I'm curious how much the lights block the view.Went with 4 cause they’re sold in pairs
I got the KC Slimlite cause of their thin profile. I’ll go measure in a bit
View attachment 52962
Those look great but can see they aren't the KC slims -- what are they? Here in Canada the KC's are stupid pricey. It would be about $1800 for 4.Bumper mount like @Chris85xlt turned out great! Thanks @Chris85xlt for all the measurements!View attachment 52533
Those look great but can see they aren't the KC slims -- what are they? Here in Canada the KC's are stupid pricey. It would be about $1800 for 4.
Awesome thank you! That's not too bad at all. I'm only planning on 2 lights, so if I put them where your outer two are they should be even less of an impact.View attachment 53742
View attachment 53743
View attachment 53744
I have about 1/2” between the grill and the back of the light. KC Slimlite 6” LED.
The outter lights also had about 1/2 of space between the grill and back of the light.Awesome thank you! That's not too bad at all. I'm only planning on 2 lights, so if I put them where your outer two are they should be even less of an impact.
What measurements are you referring to? I'm interested since I ordered your exact setup.Bumper mount like @Chris85xlt turned out great! Thanks @Chris85xlt for all the measurements!View attachment 52533