Recent content by kristof

I know about the low fuel but didn't knew about the check engine light. Will have to reset it today then

So this past weekend I experienced a weird problem. It was 7 degrees out and I started my truck no problem. Drove about 10-15 minutes to UPS and parked my truck just to go inside and drop off my package. I came back and try to start it and boom only one slow crank. So I'm sitting there and keep...

My 2020 2500 has 145K miles on it and runs great. I just replaced the OEM battery last night since out of nowhere in our 7degree temp it won't start.

$300 a piece

I'm not spending that kind of money either.

The SKF are $530 actually each side. So it's $1060. But they have 3 years warranty.

It seems they use bearings from same supplier since they fail so quickly. I think I'm going to swipe them for new ones and keep the old core and when I have time just replace the bearings and keep them just in case. Don't want to pay $800 a set each time I need to change them

Just to be specific ( I found the receipt) the originals ones were replaced at 94411 miles and were replaced with Mopar wheel hub assembles in March of 2024. I can't believe they failed already. Shop conformed this yesterday. Since they come with one year warranty Mopar won't cover them. Unless...

I replaced originals at 95K 18" BFGoodRich All Terrain T/A KO3

2020 130K miles and I need to replace front wheel bearings again. I'm not even towing anything I use it as daily driver. Mostly highways. Which brand do you recommend? Should I go with Mopar? Also should I replace both sides or just the one I know for sure needs replacement?

I hunt also so thank you for the feedback. I think my next RAM will have the ram boxes on each side ;)

Never seen those before. But I still would like to use a cover on my bed

Anyone installed truck bed storage boxes like this one below? Does it make the bed narrower? Asking because I transport plywood and drywall sheets a lot and don't want to loose the 4ft between wheels.

Z23 rotors are drilled and slotted. Maybe you mean Z17?

Did you guys installed the drilled and slotted rotors?