Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
If I fold them in then start driving they fold back out. What I would like to be able to do is fold them in and out while I am driving. Maybe there is an AlfaObd setting…
Great! Thanks for the quick response, like I mentioned I normally wouldn’t think much about this but recent concerns with other members got me thinking..
Thanks
I am bumping this thread, I just had my oil changed for the first time in this truck by a local shop, after sitting for about three hours my oil level is pretty much exactly like the picture in post #14. There is not a lot of level ground around my home so letting it sit overnight on level...
I see that, but they both are 10 ply, E rated, 126R and have a max payload of 3750lbs, at least on the 37x12.5x20s…not sure what makes them HD now that didn’t before, sounds like marketing…
Hopefully the “Increased tread durability” aka harder rubber doesn’t affect their wet traction...
The only quirk I had was not being able to display the tire pressure in any of the tiles but that was easily fixed with a setting change using AlphaODB
There is one thing I am sorting out but I don’t think it is a display thing. When I enabled the gear indicator feature using JScan I can no...
For reference I don’t know a whole lot about the air ride suspension and am following this thread to learn.
I am not disagreeing with you about you saying the HO SRW 3500 doesn’t have an overload on the bottom but on my 2023 3500 HO SRW I needed to remove my overload spring and it was on the...
It is hard to say, but it sounds like a ring and pinion gear alignment issue but I am no expert. Below is a good article that may help you narrow it down.
https://www.motortrend.com/how-to/how-to-diagnose-and-repair-a-noisy-rear-end/
Got it all installed using connections in the overhead. I used a 20-22 Posi Tap on the red wire and the blue 14-16 Posi Tap on the pink/yellow wire. Super easy, thanks for all the help!
I have the overhead console pulled down and found both wires. The red wire in the gray connector is very thin, is that the same red wire on the drivers side pillar? I am hesitant to tap into the one overhead so if the one in the pillar is thicker I will use that one, if not I will just be...
Yeah, I went back a reread everything you posted and I am not sure how I missed it….wait a minute I do know why, too much beer when researching on my end…
Thanks...Sorry, I am going cross eyed researching this.. I think I read some where that I should disconnect my batteries when messing around with the a-pillars to avoid the air bags deploying? I would never have thought to do that.. Is that someone just being way over cautious