Recent content by wrvond

2023 Laramie Sport with front camera.

I haven't tried it, but I imagine you could fold your mirrors in manually and they'd stay. Quite frankly my mirrors don't stick out any further than the ones on my old Ford did so I've not had a problem with them. I have noticed though that the do seem to work themselves out (estend) about a...

Hi, The truck only has 5600 miles on it so still has the factory filters. This occurred at 4800 miles and I did take it for a drive, it regenerated, the message cleared and hasn’t returned. Thanks!

I suspect your antenna isn’t connected.

Fifteen miles each way is going to cause problems with the CTD. Since you don't tow much you might want to look into a gasser. Unfortunately the Limited is only available in diesel. Going gas will save you nearly ten grand right from the get go, and maintenance is going to be easier and less...

When I placed my order for two sets of filters last month Geno's contacted me to say the backordered fuel filters did not have an "expected by" date and that they could refund the money on those parts or ship them separately. When I said keep the order as is and don't ship separately because I...

I've seen that kind of treatment on bolts before, though I can't recall exactly which vehicle it was on. Pretty sure it's factory.

I get that the calculator spells "BOOBIES" upside down, but I don't recall being able to perform any such antics with a slide rule...

This sounds exactly like the Ford dealerships in my area. I had a perfectly good F350 DRW that I bought new and they made it undriveable. I went to Ram not because I think those dealers near me are any better, but because I refuse to give Ford dealers and Ford corporate (no support from them at...

I'd get an electric dehumidifier with pump and run it in the truck with the windows closed (as much as possible) for a few days.

The plug doesn't exist on my '23 Laramie 2500.

My DPF gauge has shown 1/8 for "a while". I didn't check, but suspect I'm at, or close to, the 24 hour mark. No CEL. My question is: Will going on a highway run clear this? I really don't want to mess with the dealer any more than I have to.

Yes, I'd like to buy them.

Yes, you will need to get a hole saw and cut a hole in the wall for the plug and dr holes for the mounting screws.

I'm not able to find one for the 5th wheel puck system so conclude it's not offered. Any of you guys cut out holes for the 5th wheel? How did that work out?