My rig; 2022 2500 Limited Mega Cab CTD

[Texasram1]

Finally getting around to the side markers @DeepH20Driller

 

[Texasram1]

Driver’s side done, and now the pass side.

 

[QuattroCS]

Driver’s side done, and now the pass side.

smoke paint?

 

[Texasram1]

smoke paint?

Yup

 

[QuattroCS]

Yup

nice, do you have a pic of one before and after potentially?

 

[Texasram1]

nice, do you have a pic of one before and after potentially?

 

[Texasram1]

It bugged me that these were the only non-tinted light covers on a truck with the night package.

 

[CFE]

It bugged me that these were the only non-tinted light covers on a truck with the night package.

I'm definitely ordering the smoke tinted switchback lights after seeing yours.

 

[Texasram1]

Got these today; were on backorder since before I took delivery of my truck on 3/5.

 

[gimmie11s]

Great thread! I like the subs... might have to do that one mine.

 

[Texasram1]

No build updates, but a solid road trip. Sure, actual mpg is a bit worse, but not bad for a 4 people, a dog and a bed packed tighter than a tetris board. Plus, never had to stop for fuel thanks to the titan.

 

[Jsboening]

My Revolver X4s arrived this AM and I just installed it. This is my 3rd revolver, so install was a breeze.

How do you like it so far. I had the older x2 I think it was called and it was pretty good other than the glue that held the felt on the bottom failed. I heard the plastic corners on the x4s can snap off so I’m wonder which one to go with at this point.

 

[Texasram1]

How do you like it so far. I had the older x2 I think it was called and it was pretty good other than the glue that held the felt on the bottom failed. I heard the plastic corners on the x4s can snap off so I’m wonder which one to go with at this point.

The felt always came off my x2s too. The x4 doesnt have that issue, but the corners can/do snap off. I glued mine on, and no issues since. Overall, very happy w the x4.

 

[Jsboening]

The felt always came off my x2s too. The x4 doesnt have that issue, but the corners can/do snap off. I glued mine on, and no issues since. Overall, very happy w the x4.

Thanks. It seems like the best option for my rambox.

 

[DeepH20Driller]

Wow! Those turned out good. Good idea with the sheet!

 

[Linked4door]

Ready for +12V, GND and audio high levels-in.

What did you use as an input for the lc2i? Did you just take the factory wiring from the OE sub and use that as the input?

 

[Texasram1]

What did you use as an input for the lc2i? Did you just take the factory wiring from the OE sub and use that as the input?

Correct; thats exactly what I did

 

[Linked4door]

Correct; thats exactly what I did

Sweet, thanks for confirming. This is last part I needed to figure out before I start ordering parts to add 12's to my truck