Recent content by Lee Iacocca

Going pretty well for now, thank you.

Dealer has ordered a new plastic piece, says warped. I said how you know, he says we took one off the lot. I said well give me that one and I won’t have to come back. OH, WE CAN’T DO THAT….. Once I get a good bezel in I can start on the lights.

Only by pushing down on the steel hood, plastic won’t budge.

Towards the front?

Anybody here know how to remove this piece after the two bolts are out?

My last 2500 was a ‘22.

Fuse boxes and electrical architecture are different, and the mirror buttons for crying out loud, get a PhD degree for those puppies; they have their own weather system.

5.5

I took the 2 bolts out but did not get the plastic out because it didn’t want to go in either direction, so instead of breaking it I put the screws back in.

Is it time for a new Forum subset for 6th Gen posts?

Remember the center of the 3 terminals is not hot unless a fuse is in it.

Are you referring to these teeth? I don’t see anything that could hold it down.

Checked it cool this morning and same gap, gonna take it out in a while. Your thoughts are that that hood should be clipped to the top of the plastic insert? Isn’t that where the two bolts go into? Does the plastic come out under the hood or outside over the hood?

Is it two pieces, or one?

Do you have a good ground?