Recent content by John312008

I also activated the option with alpha

Here

I did because my bighorn didn't have power fold but is not needed unless you want to have power fold with the fob .

I have a 22 and I have the autofold function just replacing the door modules with 23 modules and activating it with alpha.

The black connector is behind the headlight switch if the wires in the blue stereo plug are present .

I use the green ones for the front cam and the gray ones for the trailer.

In my 22 2500 the plug is behind the rear bumper and under the dash next to the amp , I connect the front amazon camera to the plug under the dash .

Solved thanks to an old post from Jimmy If your vehicle screen is blank and you can’t access the settings, create a new profile by selecting your profile at the top of the screen. The new profile will make the vehicle screen populate, then you can go into settings and perform the factory reset.

Can someone confirm is is possible to go back to the old software in case I installed the wrong software?

I'm having a little issue After updating, my settings and control buttons are lost.I reset holding down power many times but nothing changed, my2022 uc5

Check the configuration with Alphaobd if the setting is not there the module needs to be replaced.

You need to find some replacement pins and the will be use in the connector 5 or E, in the door Module.

I was thinking the same but If the guy in the gas station parking lot did it I can give it a try ,this is the final result.

Actually I find the yt video here in Hdr.

I did it in mine but I replaced the door modules with the mirror power fold from a limited here is the diagram ,