Just wondering if anybody that has put one of the Override Switches on there AMP Running Boards would
have a picture of where the wires go in the connector that plugs into the control module? I purchased a switch
and it did not come with the instructions. The instructions AMP provides on-line does not have the diagram.
AMP Research's customer service is not very good, sent them 8 emails requesting the information in the last two months
and not a response.
Thanks...............
have a picture of where the wires go in the connector that plugs into the control module? I purchased a switch
and it did not come with the instructions. The instructions AMP provides on-line does not have the diagram.
AMP Research's customer service is not very good, sent them 8 emails requesting the information in the last two months
and not a response.
Thanks...............