CortexM0
Active Member
- Joined
- Jul 15, 2022
- Messages
- 164
- Reaction score
- 217
I needed to temporarily run some wires into the bed of my truck. I wanted a fairly clean install, but didn't want to permanently modify anything since I was going to have to remove it in a few months. I ended up 3d printing a grommet to replace one of the existing plugs in the front of the bed.
Just pop the existing plug out, and snap this one in its place. The hole is sized for 3/8" loom from H.F. Tools. The slit allows you to twist the plug open (prior to installation) and slide existing wires into place.
Files can be found here: https://www.printables.com/model/701061-2023-ram-2500-bed-grommet
Just pop the existing plug out, and snap this one in its place. The hole is sized for 3/8" loom from H.F. Tools. The slit allows you to twist the plug open (prior to installation) and slide existing wires into place.
Files can be found here: https://www.printables.com/model/701061-2023-ram-2500-bed-grommet