Recent content by MarkCO1

Finally got some time and I built the rear deck for the Ram. Pretty happy with it.

Spring Bath. Wife vacuumed the interior, interior datailer on the dash and doors, cleaned windows. I power washed the underside, then the exterior and bed, detailer on the tires. Put it away then pulled it out this morning and detailer on the outside. I use Lucas Oil Slick Mist detailers...

Take wolf repellent. :rolleyes:

DD and towing under 12K, I'd go 3/4 ton gas. Mostly towing, 1 ton Diesel.

Many rural locales, not heavily enforced. Some State Patrols really get busy with it on the Interstates. That said, even if "not enforced" if you are in an accident and braking is any issue at all, you might get into the weeds with insurance. I work (professionally) accident reconstruction...

A little editing in Photoshop, that could be a wallhanger of a photo. :)

The Chill Cubes are pretty amazing (in comparison to the old stuff). 40% more efficient and you can vary the levels. No soft start needed.

I'm hoping the 8K and 12K chill cubes are out soon.

I've seen several folks just get the Auxito direct replacements for the Halogens. They have their own circuit boards internal and are plug and play from what I can see from many who have swapped them out. Has anyone actually tried the Auxito? I used them in my 2011 and was happy with them.

This past week, took the 2500 on it's first road trip. 1955 miles. We towed the 6200# dry (about 7400# loaded) trailer to Phoenix and back. Had some rain, sleet, blizzard, slow crawl past accidents, hills and passes. Averaged 10.1 mpg with a trip average speed of 56mph. That includes the...

Each double line of screws holds a panel at is about 3x5 feet. This is before it was taped. It was some time effort, but I know it's done well.

$45 for a gallon, $45 for a Sprayer, $5 for a Tyvek jumpsuit. Call it $60 a year and a few hours. I'm wanting this one to last until I can no longer drive. :)

Intermediate Gas 16" is where it's at. :cool:

Those of you who use it, do you power wash the underside first? I assume so, but just straight water. I'd assume any soap in cracks and joints would reduce the effectiveness.

And with a longer gas system, will be softer, longer lasting and more accurate. :)