Definitely a glitch in the matrix. The top and bottom photos are distinctly different, yet at the bottom they are the same.
Slight difference, not a huge improvement.Definitely a glitch in the matrix. The top and bottom photos are distinctly different, yet at the bottom they are the same.
View attachment 67555
What a great idea. Mine are already scuffed up from climbing in and out.Got the boards on, more pics to come when I get her outside
Slight difference, not a huge improvement.
For what it’s worth I think the Baja designs kit is worth the money
View attachment 67558View attachment 67559
What a great idea. Mine are already scuffed up from climbing in and out.
Absolutely much more light there. But they hang below bumper, and cost 3x. Not what I wanted. I’m pleased with my mod all around!Slight difference, not a huge improvement.
For what it’s worth I think the Baja designs kit is worth the money. Old pic.
View attachment 67558View attachment 67559
Could you take another photo with your phone/camera on the ground looking up? Ideally showing the middle of the winch to the outside of the frame if possible.Here you go, best I could get the lever is located on the driver's side. Yet another reason for needing a lift in the shop!
Looks like someone's dog didn't waste any time getting to your tire.Got her some new shoes.
Stock suspension with factory off-road package. Airlift 5000 bags in rear at 0 psi.
Falken Wildpeak A/T3W LT285/75/R18 (aka skinny 35’s)
Rear fender height 43-7/8”. Front 41”.
Adjusted tire circumference with AlfaOBD to 2685mm and speedo is dead on my GPS app.
View attachment 67659
View attachment 67660
View attachment 67661
LOLLooks like someone's dog didn't waste any time getting to your tire.
Unfortunately, I can't get a good shot lying on the ground looking up. I took a few shots of the brackets and how they mount to the frame.Could you take another photo with your phone/camera on the ground looking up? Ideally showing the middle of the winch to the outside of the frame if possible.
I am curious how that vice winch mount will fit/interplay with the front hitch I have hanging down on mine.
I asked the Vice team last year and they said they couldn't confirm it but that it should fit as the hitch brackets are all outside, and theirs are all inside, but I am also interested in where the crossmembers fit.
Shamelessly, I'm also curious how much reaching under it is to get to that handle vs clocking a Warn or Smittybilt to reach through the lower grill.
Thanks, that's helpfulUnfortunately, I can't get a good shot lying on the ground looking up. I took a few shots of the brackets and how they mount to the frame.
How are those at low speed? Some say they are noisy others say they can’t hear them at all.Hopped the boarder and picked up the balance masters I ordered from CJC. Removed the centering rings I had on before and all the wheel weights, took it for a quick rip down the highway to 110km so far so good. No more vibrations and can hardly tell they are installed visually. Excuse the dirty wheels
View attachment 67712View attachment 67713View attachment 67714View attachment 67715
I believe the Balance Masters are silent. I purchased Centramatics and removed immediately . They were very noisy, to the point it wold mask any wheel or brake issues.How are those at low speed? Some say they are noisy others say they can’t hear them at all.
The balance masters are silent as they are filled with "Quick silver" liquid in a bladder. I think centramatics make some noise as they have balls rolling around.How are those at low speed? Some say they are noisy others say they can’t hear them at all.