When blend door fails, what fails exactly? Is it the actuator(s) or something else?
I did a bit of reading and there's a lot of talk about actuators and it appears they aren't very difficult to replace?
Or is there something else that needs to fixed / replaced to get things right again?
The symptoms are the I only have heat on the passenger side. When I turn temperature down, I have full blast from the blower on both sides but when I start turning temperature up, the passenger side gets warmer while still blowing at full speed, drivers side however just less and less airflow as temp goes higher and higher and there's barely any air coming out when temp is on HI, whatever is coming out is still cold though.
I'm pretty handy fixing stuff but don't want to bite more than I could swallow if I have to rip a whole front console apart that may be too much work for me.
Anyone has any experience dealing with it outside of warranty?
I did a bit of reading and there's a lot of talk about actuators and it appears they aren't very difficult to replace?
Or is there something else that needs to fixed / replaced to get things right again?
The symptoms are the I only have heat on the passenger side. When I turn temperature down, I have full blast from the blower on both sides but when I start turning temperature up, the passenger side gets warmer while still blowing at full speed, drivers side however just less and less airflow as temp goes higher and higher and there's barely any air coming out when temp is on HI, whatever is coming out is still cold though.
I'm pretty handy fixing stuff but don't want to bite more than I could swallow if I have to rip a whole front console apart that may be too much work for me.
Anyone has any experience dealing with it outside of warranty?
