Step Bars

[ernursing21]

Does any know if the 2018 Ram 2500 step (nerf) bars will fit the new 2019 Ram 2500? Is the bolt on pattern the same since the Cab did not change?

Thanks

 

[DevilDodge]

I do not know for sure...but I would be surprised if they didn't. Since nothing was done to the cab floor...I do not see why they would have changed this.

But, I haven't seen anything specific.

 

[Deleted member 80]

I would guess the same, BUT there are enough frame and mount changes to make me wary. Not a gamble I'd take without better info.

 

[Shane]

Is there any update or new experience with regards to this question?

 

[hutchman]

I have a set of 2018 side steps on mine and they fit fine......BUT, Amp steps for a 2018 gas truck will not fit on a 2019 gas truck. Amp steps for a 2018 truck will fit if your 2019 is a diesel. But not on a gas truck.

 

[Nordic28]

Rough Country nerf steps bolted on perfectly in the factory holes.

 

[1stStrike]

I bought some Tyger step bars of Amazon. They were listed as fitting a 2010-2019 so i decided to take a risk and bought them. They fit for the most part. The only issue seems to be the center section of the bar were only one of the bolt holes lines up.

 

[Bighorn]

i installed the black OEM mopar steps. I liked the size of the step pads and the higher stance of them. Aside from installing the nuts (time consuming), they were easy and fit perfect.

 

[fao1]

which fender flare are those

 

[Bighorn]

They are the factory Mopar flares for a 2018 (and earlier). Common on the off road package trucks. I purchased them from a local Ram dealer. Aside from removing some snap on/off plastic trim that came on my truck, then cutting off two alignment tabs on the flares, they went right on. I like the looks of a black flare with the other black parts on the truck.

 

[TogaLock77]

I tried the Rough Country drop steps and they weren't even close despite advertising as such. The bracket were a good inch off both vertically and horizontally.