sPOD, Switchpro or Auxbeam?

[Craig2011]

What aux switch and power distribution system are you using for your lights and accessories? sPOD, Switchpro and Auxbeam seem to be the most popular? Thanks!

 

[deanfx]

OEM aux are probably the most popular here. I don't have the OEM aux so I'm using a CTS Edge3 monitor to power my light bar and rear lights.

 

[Crusty old shellback]

I built my own with some switches and relays. Details in my build thread.
Being a Power Wagon, the OEM Aux switchs were not really a option. Put the switch panel in the overhead. Controls rear work lights, front running lights, front floods(low beam) front floods and spots (high beams).
I have 4 front lights grouped in 2s.

 

[Craig2011]

I built my own with some switches and relays. Details in my build thread.
Being a Power Wagon, the OEM Aux switchs were not really a option. Put the switch panel in the overhead. Controls rear work lights, front running lights, front floods(low beam) front floods and spots (high beams).
I have 4 front lights grouped in 2s.
View attachment 78298View attachment 78299
View attachment 78300

Very cool! How hard was it to run the wire down the A-pillar?

 

[Crusty old shellback]

Very cool! How hard was it to run the wire down the A-pillar?

Simple. There is plenty of room. Hardest part was going from A pillar to under dash. But it wasn't that hard.

 

[usernamechecksout]

I installed OEM Aux switches.

 

[Wholeo]

Crusty, that is a clean looking inatall!

 

[Crusty old shellback]

Crusty, that is a clean looking inatall!

Thanks. I was really nervous about cutting the hole in the headliner. But it worked out a lot easier than I thought it would.