I am installing a retractable tonneau cover and need to install drain tubes. MY bed has factory sprayed-in bed liner. The oval caps near the front of the bed or the circular caps next to the tie down straps were sprayed over. Can I use either of these to put my drain hose out of? I was thinking about drilling a hole in those caps, but not sure if that's the right move? What are your thoughts?
Ram Heavy Duty Forum
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Installing a retractable tonneau!
- Thread starter abbottc23
- Start date
F3arl3sslimited
Member
- Messages
- 65
- Reaction score
- 53
- Points
- 18
Mine is routed to the oval caps, I didn't install it.
Razzman
Well-Known Member
I used the caps as well on my Retrax PowerTrax, but I made a mod before running the hoses. I took two 90 degree plastic vacuum elbows and sanded the diameter of one leg on each until it fit into the rubber on the bottom of the can, then I attached the hose to the other end. This gives me storage room under the can without the hoses in the way.