Cummins Creep
New Member
- Messages
- 5
- Reaction score
- 0
- Points
- 1
Well Here I is! New to the site, but not new to Ram Trucks, or Cummins either. My newest project is to rebuild my steering. I have an 2004, crew cab (SLT), 8ft bed, 2500 with 141,000 miles on the clock. I'v owned the truck for 4 yrs now. My first ever Ram was a 2000 and went through the whole VP44 thing and the front end on that truck , and some electrical glitches as well. I'm going through the front end, already switched the gear box out the the large shaft Mopar unit, wheel bearings, axle u-joints, brakes, and the T to Y switch as well. What I'm doing now is a new Thuren Track bar as well as a Sway bar install. I would like some input as to the Thuren alignment spec's, do they work and does it make a difference in the handling? No rust where I'm at so Ole "Dodgy" should last a long while here. Thanks for reading my introduction and hope to share my discoveries well you guys here. "Keep your powder dry"
