Front bumper parking sensor extensions

[mopar32]

I have 2024 - 2500 longhorn limited, that I installed a 3" Westin bull bar. The bar blocks the center sensors and they need extended out past the bar. Everytime you start/stop they dash board lights up error, but goes away when you start driving. I see they make kits for the 1500, but even westin say they don't make them for the 2024- 2500's. I would think long and hard before placing a $300 westin bull bar will cost you closer to $1200 + extend the sensors. Had to pay $900 to have the front bumper removed along with the factory tow hooks. It is a good look, but not sure if worth it.

--My question is do they make a plug and play kit, or do you just cut them and piece it out with wires? I see they sell the sensor holder brackets that you can screw into your application.



---from westin --- we sell the bar, but no fix for your sensor

Thank you for your reach out to us about sensor relocation kit for 2024 Ram 2500.

I regret to inform you that we do not have a sensor relocation kit for the 2019-2024 Ram 2500/3500 HD trucks.

We apologize for any inconvenience this may cause. If you have any further questions or need additional assistance, please do not hesitate to reach out.

Thank you for your understanding.

Best regards,



Ray Napoles | Customer Service Representative

 

[Darkside]

I used the Westin relocation kit on my Go Industries brush guard, I had to cut and splice the sensor wires, cut a notch in the bottom of the relocation brackets for wire clearance, and put a “custom” washer on the bracket for the sensor to fit properly, my truck is a 2021.

 

[Wrayzor]

I cut and spliced mine and they work with no issues. Just use the same size wire.