Fisher Plow Mounts Issues w/ Carli Sway Bar & High Mount Stabilizer

[BlackBear306]

I just put a 2.5” Carli leveling kit with the high and low mount stabilizer and sway bar on my truck (‘22 Ram 2500). With the new mounts for the sway bar, my Fisher plow brackets to reinforce the actually plow mount don’t fit. Has anybody gotten around this, or is custom brackets the only option? Or I guess anyone who has run it without, any issues? I don’t plow with it professionally but it is a 9’6” XV2. Thanks for any insight!

 

[H3LZSN1P3R]

Custom brackets will be the only way or ditch the sway-bar you cant run without the plow brackets on the sway bar bracket especially with a 1050lbs plow like your XV2 blade. I don’t even run a sway bar its much better without a front sway bar when plowing over uneven terrain. I have a Fisher 8’6” V-plow.

 

[DIRTRIDER]

I had an interference issue with a Thuren frt sway bar and my SNOWAY plow brackets on my ‘22 . I ended up swapping the plow brackets from side to side and that created the room I needed for sway bar.

 

[BlackBear306]

Thanks all for the input here. Just wanted to close the loop for any others with this issue. I ended up going to a local welder who helped adjust the brackets to fit. The issue was mainly that the ends of the bracket were welded on the inside vs outside which didn’t allow enough room to fit over the sway bar bracket. The bracket that goes under the high mount stabilizer mount was a little trickier but just a bit of tweaking to those ends and all set.