Pressure_welder
Well-Known Member
- Messages
- 269
- Reaction score
- 275
- Points
- 63
Good morning, hope everyone is doing well. I just have a couple questions regrading a 5500 60" C/A i have on order. I have an existing custom welding bed 8ft x 10ft that ill be putting on it that was actually built for a 2012 GMC denali dually. So as far as i know about my only issue there is i may see a touch bigger gap from cab to deck as i believe pickups are 58" C/A so i should have about 5" gap which is fine with me. However one thing i didnt consider is frame width on a 5500.... would any of you fine folks happen to know the frame width on these 5500s? i am thinking potentially the frame rails on my existing deck may be too narrow i think 34" outside dimension. I DO have perpindicular sections of heavy wall tubing in 3 locations along the frame rails that were meant to meet up with the existing pickup bed mounting locations if memory serves correctly those sections were 38" long. I did find a PDF on 2013 ram 45/5500s that say frame with is 34" not sure if that still rings true for a 22
another question i had was, with these 5500s, being i ordered a laramie lvl 1 pkg, i also got park sense front and rear. I imagine these sensors would come in a box and plug into a harness on the truck once i install? would the same be true for the backup camera?
another question i had was, with these 5500s, being i ordered a laramie lvl 1 pkg, i also got park sense front and rear. I imagine these sensors would come in a box and plug into a harness on the truck once i install? would the same be true for the backup camera?
Last edited:
