Hello all, after a while of owning my 24 big horn I decided I wanted to get a full center console. However I am cheap. I decided to roll the dice and try a 1500 console as I couldn’t find a clear answer on the internet on if it had been done.
Well it fits, as we know the floor is slightly different so there all small gaps near the foot wells but with weather techs in you can’t even see it.
I was able to bolt the front up using a 2500 front console breaket without issue. I am unsure on the rear as they appear to be on National back order.
As far as electrical the 2500 and 1500 use the same connector but the pin out if different. I simply ordered a wiring harness for a 2500 console and will swap the console side to match the truck. I haven’t done this as the harness is about 3 weeks out. But I thought it would share some pictures of the fitment anyways. Once my rear bracket and harness show up I will do a full write up with part numbers.
So far the 1500 console was 300 bucks, wiring harness was about 100. Then about 120 for the front bracket and dash close out strips. This should be about half of what a 2500 console goes for.
Well it fits, as we know the floor is slightly different so there all small gaps near the foot wells but with weather techs in you can’t even see it.
I was able to bolt the front up using a 2500 front console breaket without issue. I am unsure on the rear as they appear to be on National back order.
As far as electrical the 2500 and 1500 use the same connector but the pin out if different. I simply ordered a wiring harness for a 2500 console and will swap the console side to match the truck. I haven’t done this as the harness is about 3 weeks out. But I thought it would share some pictures of the fitment anyways. Once my rear bracket and harness show up I will do a full write up with part numbers.
So far the 1500 console was 300 bucks, wiring harness was about 100. Then about 120 for the front bracket and dash close out strips. This should be about half of what a 2500 console goes for.
