Search results

Are you gonna be using jscan or Alpha to change settings for the factory LED lights?

This is the only picture I could find and I hadn't swapped the fault sense wire or installed the cavity plugs. The backside of the connectors are numbered 1-6 (top)and 7-12(bottom) for the different cavities. You will see these tiny numbers on the outside edges of the connector. You can use the...

Sold...

Sold....

Yes, this is the cable you would need to communicate with different modules and change settings.

Brand new... Purchased a couple months ago but never installed and I am gonna sell the truck so won't need it. Sold

Pending...

Sold....

When you are looking at the inside of the plug, the terminal locks will be secured in place by a white cap. This cap has a slot in the edge of it to pry it forward with a screwdriver. On the 6 way connector- Remove this cap entirely. Pry it to the release position and then pry a little more to...

Awesome, Thank you! Let me me know how this works out for you and what all is involved once its working. I was thinking of doing the same next spring since I will have the camera at that point..

Does anyone know if the third brake light from incandescent to LED(style with camera) is a straight swap for lights to work? The 4 pin connector looks the same. Might look into getting camera working in feature but not immediately. Just need the light's to work. This⬇️ To This⬇️

Delete

No longer available..

Takes about 5 minutes to swap the connectors. Super easy. Just pull wires and put in new connector. Both are Molex MX 150 style connectors so you dont need a different style female terminal. If anyone else decides to give it a try here are the part numbers. Top bag was the 12 pin connectors and...

I got the connectors and all pins needed.. cost me $20 total with $10 of that for 2 day shipping.. Thanks again!

If I was you I would take it in to the service department and tell them something is definitely wrong and it needs to be fixed. I'd guess it needs the freon level adjusted or the recirculation door isn't operating correctly. As far as the HVAC working hard and being loud, you could try the...

For the AC issues.... Window tint would work great to help that AC. I'd go with a high quality ceramic like Llumar. Even if you go with a 70% VLT it will not look obvious and it will be hardly noticeable if laws prohibit. The cermaic will stop a lot of the Infrared rays= heat from coming through...

Ok. Should be easy enough to get the right parts with that info. I just wanted to know what hardware was needed for the swap. Thank you for the info.

What all hardware was needed? Do you happen to have the part numbers? I'm considering doing this as well... Looks great!

Good to know! Did they end up repairing it or replacing the hood? Nevermind, I went back and read your post which I should have done first.. Maybe I should wait until next year then and have it repaired. I'd like to find a way to talk the body shop into taking the money Stellantis will pay to...