Search results

No sir. Stock setup

Small addition but installed the NH Overland panel under the front seat. Now to add a couple things to it.

After some time I was able to get my truck into the dealer for the clock spring replacement. Got it done yesterday and the steering wheel heats up as it should. Hopefully this ends the issue on my truck.

That's sweet @flatfish. Hopefully my repair will be as quick and with the same result. I have the truck back now. The dealer had to order a module and clock spring. When those arrive they'll call and swap those out. hopefully that takes care of it. Will keep yall posted.

@Metternacht i’ve read this thread a couple of times and empathize with you on this one. Hell I’m just getting started and it’s annoying. honest to God if they can’t figure this crap out this week I may just say F it. I’ll drive this thing till it dies and by that time it’ll be the least of...

I don’t buy the turn signal theory either. Here’s where I am as of tonight, without the truck out in front. - diagnosed as a bad steering wheel - replaced steering wheel - notified that the gauge clusters weren’t working at all with new wheel - higher ups got involved and fixed that issue...

I asked told them the various causes I have learned about via this thread and a facebook group and this is what they discovered. I told them specifically about the clock spring and they said if the turn signal still functions properly (turning off when the wheel straightens out) that the clock...

Took mine in this morning for the same issue. Dropped it at 7:30 and by 10 had the diagnosis that they were replacing the steering wheel. Time will tell based on all these reports. I'll keep yall updated.

My wife has had that setup in the far back of her SUV for years. it's held up really well and other than a small stain it looks like new.

I have a 22 laramie. the seats fold up and there is the fold flat floor panel system that unfolds to create a flat floor. they fold up over the storage bin on the driver side and the sub on the passenger side.

Where’d you get those sill guards? Appreciate it in advance.

Got the Bak Revolver x4s installed yesterday. 3rd time opening it and the cable came off the driver side latch. I called Bak and explained that I wasn’t thrilled with the situation of having a broken unit before I could even register the warranty online. They are sending me a new locking...

No. Strange occurrence and like you it never came up again. Let's hope it was just some stupid computer glitch.

Good catch... didn't catch that on my end when I searched the topic....

Gas

I think mine has done it too. I have to hit the fan speed up or down and it stops. Strange thing is it only sounds like it's on the passenger side. I have never felt the wind increase on my driver side. It sounds like a sudden rush of air pouring out of that side but of course i'm driving...

following this because I have noticed the slightest delay in acceleration at low speeds today. Was searching on here for info and this is the closest post I can find that describes what I felt. Mine was very subtle. It happened under a slow, easy acceleration from a stop sign. I'd guess...

Added the TVD Vinyl decals tonight. I didn’t wash the truck but did washed the spots where the vinyl went really well. Happy with the outcome. I was in between leaving the badging and removing it and thought I’d try this for a cleaner look for a while. I screwed up the border on other side...

Great question @Slamman18Z looked it up and it states a 15lb max capacity.

@Brutal_HO i got them from a place called TVD Vinyl Decals. They’re pre-cut and work great. You can find them online. Sorry for the late reply. Was away on vacation for a couple weeks.