Recent content by welderjay

@jasmith348 I run Amsoil in mine and have since I first bought it new 5/21. First oil change was at 4k miles. I am oil crazy, so it rarely sees 4-5k before changing, more frequent lately with all the issues. My problems didn't start until 19k miles. Truck is still in the shop starting on the...

Mine has been in twice since my last post. It's had the EGR replaced and is on it's second STAR case. It's in the shop again having everything from the turbo back replaced. It's been in the shop for 2 and a half weeks so far this time for a total of 21 days out of the last 3 months. I sent an...

Same issue on my '21 SO 2500 CC. I have been having a p2459 code every 600 miles. I brought it in to be seen not long after having my first p2459 code repaired because my oil test report said I have 10 percent fuel in the oil. Dealer said to keep driving it and to bring it back for them to...

On my '21 I have been having a p2459 code every 600 miles. I brought it in to be seen not long after having my first p2459 code repaired because my oil test report said I have 10 percent fuel in the oil. Dealer said to keep driving it and to bring it back for them to service and do their own oil...

Thanks for the clarification. I haven't looked into AlfaOBD and assumed it would be similar to the tazer needing to be in the OBD port continuously to function.

I only ask because I was able to add remote start at the dealer by having them add the BCM code and program the FOB, and would prefer to not have to use AlfaOBD if possible as I would also need an OBD splitter as I have a OBD device plugged in already

Awesome. Do you know the BCM code so that I could have my dealer add it so I wouldn't need the AlfaOBD?

Thanks for the reply, do you happen to know if the harness will work between the 2?

@Jimmy07 So just to be clear- I have a 2021 2500 tradesman I want to swap the halogens to LED since the light quality and distance is horrible I can swap my stock lights to the mid level LED lights without needing adapter harness or AlfaOBD and it is plug and play? A forum member replied...

Thanks! I went full stupid and ran GXL or SXL or some xl wire to add a 12v cigarette style plug and ran wire so I can run an inverter larger than the 400 watt stock unit, but using factory looking custom receptacles to run higher wattage. These are pics of the bezel frame attached to the...

The yellow piece pulls straight out to allow access to the USB and 110V wiring. After the yellow is removed and wires disconnected the blue pulls straight horizontally toward the rear seat, there may be a screw in the lower part below where the 110 plug would be , but it should be easy to spot...

Thank you for posting this. I just ordered the parts you listed and am ready to install but have a few questions. You had to run the the 68096423AC from the in dash usb to the rear hub under the carpet. But the seat harness you ordered taps into the harness under the driver's seat and also goes...

There is no module to add. If you have the switch on your hood latch and already have a fob that locks and unlocks you have all you need except the new fobs with start function and the added XBM code. I had to try a couple dealers before I found one that was receptive and willing to do as asked...

So after having my dealer add the code and having no issues I just noticed I have no stereo control for the remote start. I thought you could disable the horn honk using the settings or controls page? I have the 8.4" u connect. I have a 21 Tradesman EDIT_ Nevermind it's under the doors and...