Recent content by StadlerMat

Is the space where there isnt a button dead? In other words could I just use that spot as a flat panel to mount a small surface mount switch or is there something behind that that would prohibit that?

On the center dash under the UConnect screen and above the wireless charging pad and to the right of the trailer reverse steering knob there is a bank of buttons. On mine there are functional buttons for parking sensors front and rear off/on, tow mode and exhaust brake but there is an unused...

Cortex did a writeup on all of these things on this forum if you want specific details but short answer would be not UNLESS you wanted wait until the DRVM camera is available and install that in your cargo position instead of as a true DRVM camera

Well. Jumped in the truck this am and voila the screen appeared.

Been a hectic little bit but finally got time to install my gateway module and then open up Alfa to enable TSVCM. @Jimmy07 i went in under body computer - active diag - car config change then found TSVCM under cabinnet using the search feature and changed it from disabled to enabled. Finished...

Link to EX support for others that may need it. https://www.obdlink.com/windows_qsg_ex/

Mike from KOADtech responded to my email to confirm that my original installation was correct so I’ll redo that in the am after I get through my morning block of meetings and other work things. I have a window in the afternoon to try and check firmware and drivers on the OBDLINK EX unit. We’ll...

I don’t have the MX. I have the EX (connects via wire to USB port on PC) and to my knowledge they don’t provide a link for updates to that unit. Do you see one?

Installed the KOAD Tech sbm today on my 2023 RAM3500 Limited trying to follow both the instructions and the pictures from the forum. As others have noted the wires and connector colors that came from KOADtech do not match the instructions and the ends weren't tabled "to black" or "to white" as...

Ok. Got it done. For those that want to do this themselves this is how I found easiest to do it. - remove screws from back of 12 pin - slide watertight gasket clear of rear section and then slide back rear section to give yourself room to work. - cut 2” or so of the heat shrink to give...

I see the issue now. That picture held a lot. Thanks.

Maybe. The barrel terminating tools in my set couldn’t slide in the way it normally works. I’m concerned that the SAE spec on the connector means that it’s a sleeve type that is epoxy bonded into a sleeve which then presses with a compression tip into the open end of the pin and once the epoxy...

Hi ya'll. Does anyone have experience with removing the pins from the 12 pin connector. I had no issue dissembling the housing down to where I could see the back wires going into the terminals that serve as pins on the front. My experience is that there is usually little wings that have to be...

Bump for a little help please to question 1 above. QUESTION 1- it isn't clear to me where the bracket and gateway module are supposed to mount. Is it here? attachment 13 Can someone please post a slightly better picture than the one on the right in the attachment as to where the gateway module...

Yeah. That’s what I thought. Any input as to the rest of my plan is greatly appreciated. I reckon I just will wait until RAM finally figured out the DRW camera. Does anyone know yet if the ‘24 models will have that same camera as the ‘23 models?