Recent content by OC455

A little over 41k at this point.

I adjusted the lights to get them to have a better beam pattern. I hope the photos show it. I was on a dead end roadway that does not see hardly any traffic so no worries about on coming traffic. I initially adjusted them in an old airforce bunker area. Let me know what you guys think. All...

With only the parking lights on and the back light. Spot light pods. Both need adjustment. Combo and ditch lights. No spot lights. All on. All of them need to be tweaked to shoot farther out and have a good spread.

Some night time pics. I have to adjust the pods. Need a flat area with some distance.

Spot lights are the center. Spots and the combo with the ditch lights on. Morimoto NCS BigBanger spot lights (2) Morimoto NCS BigBanger combo lights (2) Morimoto NCS Bigbanger combo ditch lights (yellow) (2) with Morimoto ditch light brackets. Morimoto BangerBar wiring harness (1) Diode...

This is the back light with no parking/headlights on. This is the back light function with the parking lights on. Automatically dims the back light.

Here are some updated pics.

I had the lights wired up today. Seeing how it's coming to the end of the year and I have a lot to get done before the white stuff hits, I opted to take my truck to JPJ Communications and have them run the harness and have them get it done. They primarily install equipment and coms in all of...

I've installed my Randy Ellis Design Sleekster light mount and my ditch light hood brackets. I'm using Morimoto BigBanger NCS light pods. I do not have it wired yet, trying to figure out the best way to route the harness for a clean install. Just some pics of the pods temporarily mounted on...

More worried about compromising the integrity of the harness seeing how everything is all computer controlled. It looks like there is a double seal on the positive side connection and I can keep it from getting water/dust intrusion.

I think I found a better solution to what I want to accomplish. Looking at the fuse box, there is a fuse F79 for the ID/Clearance lights I think I will use a fuse tap to to get the signal from.

I think I found it: Pin Information CavCircuitGaugeColorFunction 1L430.75WH/DBLEFT LOW BEAM DRIVER 2Z9070.75BKGROUND 3L330.75WH/GNLEFT HIGH BEAM DRIVER 4Z9070.75BKGROUND 5L610.75WH/GNLEFT FRONT TURN LAMP DRIVER 6L5510.35BG/BNLEFT FRONT LIGHTING FAULT SENSE 7L770.75WH/BNLEFT FRONT...