Recent content by Golfnut

I can confirm that this set of instructions works on a 2024 2500 but there were two typos but infortunately I don't recall the correct spellings!....cust.set.menu is cust.sc?.menu and rear light dts disable is also slightly wrong. It was my first time using AlfaOBD so I struggled but did get it...

The pickup is in a garage on the other side of my yard so I'm not going to go look but its in the engine bay fuse box. When facing the pickup it was towards the top left of the box.

I installed a business band two way radio in my 2024 Ram yesterday. Its a Laramie with Cummins. It does not have the upfitter AUX switches. I contemplated just going straight to the battery and trusting myself to turn the radio off when I know the pickup will sit for a while but I used my...

That is some of the best news I've heard! The bed came off a 2009 and is going on a 2024 so the mounting brackets have to be changed and hopefully they can get it done on the 2nd week of January.

I have a 2024 2500 that I am going to have a Pronghorn Utility body installed on. The bed dealer/installer is a little concerned about install height because of the factory gooseneck hitch system the pickup has. How difficult is it to remove the OEM hitch and puck system? I assume it is just...

I have a 2022 Laramie that didn't come with a gooseneck ball so I put a B&W in it. It was not hard and took me only a few hours and is very clean looking and the bed is very usable with the ball flipped down. I also have a 2024 that has the factory setup in it. I hate the extra holes in the...

I have a 2022 2500 with the 12" UConnect system and from the iPhone app I can remotely start or stop the engine and lock or unlock the doors but the app has not update the fuel level, distance to empty, mileage, etc in about 9 months. What am I doing wrong?

I have a 2016 Pronghorn Utility Body that was previously installed in a 2009 Dodge Ram 2500. The 2009 was banged up in a farming accident and I replaced it yesterday with a 2024 Ram 2500. I've been told by Pronghorn that the body will fit on the 2024 but that the mounting brackets may need to...

I am. I'm not overly concerned about damage. I suspect that the dealer's employee who prepared the truck for shipping/final delivery put gasoline in it before loading it on the truck for shipping. I drove it today several times on short trips and it runs and idles perfectly fine.

Update #2.....The filters I used were genuine Cummins filters from the local parts shop. I have no reason to question them. This morning I put a long drain hose on the fuel filter base and jumpered the fuel pump relay and was able to pump the tank entire empty. After that I put a few gallons...

Followup...I changed the filters this evening. The rear filter (water separator) was definitely dirty. The fuel filter on the engine looked good decent but I change it anyways. Here's the scary part. It was late and I was tired but I kept thinking it smelled like there was gasoline in the...

Very good chance. I looked at the filter assemblies and everything looks way to clean to have been changed.......or maybe hasn't been changed at all

Last week I purchased a 2024 Ram 2500 with the Cummins sight unseen, with the exception of some pictures. It only has 10,000 miles on it so I figured there couldn't be too much wrong with it. It was delivered today by a third party and it is everything I expected it to be and looks like new...

Get a Milwaukee M18 compressor or a tire inflator. I have a gas powered compressor on my service truck but I only use it for blowing equipment off. Tire inflator does everything else.

I wrecked my 2009 2500 with a Hemi in it this afternoon. It was being flat towed by a tractor and grain cart and the hitch on the cart snapped off. The pickup then slammed into the cart. My feelings are not hurt too bad as I've wanted an excuse to get rid of it for several years. I'm looking...