Recent content by dave41079

Updates on my foot. Got my splint off on Tuesday. You can definitely tell this was done by an ortho doc. Define muscle atrophy:

107 here.

I had some KM3s on my 4R for a while, they did great. Way tougher sidewall than the KM2s, but the KM2s were better in rocks...until you sliced a sidewall.

No. They don't work at all with Ramboxes because the side rails go along the top of the bed. When I ordered the truck I was deciding between Ramboxes and a tonneau cover, or regular bed and a Softopper. With this setup I can put a cot in the bed and easily camp with plenty of room, and also put...

Did some truck things last weekend, and realized I hadn't put a picture up yet with the Softopper on. Also had achilles surgery on Monday, so truck/Jeep things will be on hold for a (long) while. No I'm not on house arrest also, that's a battery powered SCD to keep me from getting blood...

That's not a bad price at all. I like it. Good work!

You can use a composite video switcher or coax switcher, you would just need to have adapters from fakra to whatever input the switch uses. I'll probably just have the cable ends easily accessible and just manually change them as I need to. Put the Softopper on/up and connect to the rear. Put...

I have a solution for that. You just need a new camera (around $100 for the same one that's in the CHMSL), and some fakra z extension cables. You can either connect directly to the mirror, or connect where the current camera wire is behind the CHMSL. I actually intend to run two wires down...

Likely better off with new wheels, I just really like the 75th AE wheels I have. I'll also wear out these 35s before I buy 37s. Next thing I need to look into is a low-pro sharkfin so I can still fit in the parking garage at work. I doubt that's even a thing though.

Oh yeah I'm not new to any of this. I've had great results with Motorsport Tech/BORA wheel spacers and adapters in the past. They will make them any size you want, hubcentric to the vehicle, hubcentric to whatever wheel you're using, with or without studs. They do great work and are pretty...

How large are you thinking on a spacer, and where from?

Exactly. Ideally one inch, but I'm not sure there's enough depth in those pockets.

I love this. Might be doing the same thing to mine now.

Perfect, thanks! I was hoping the pockets between the studs would be a little deeper.

Can you snap a picture of the back of your factory wheels? I'd like to see the mounting surface without having to remove one of mine right now.