Baja Design reverse lights triggered by aux reverse switch

[Smittys2500RAM]

I just installed these yesterday and tapped into the white with purple wire located at the passenger side brake light area. If there is a way to also have them trigger with the cargo / reverse mirror lights that would be amazing!!!

 

[Smittys2500RAM]

You can use AlfaOBD to enable the lights in reverse. MS and CA don't allow it to be programmed that way from the factory.

I like what I'm hearing!! excuse mt ignorance here but how do i get that done? Sounds like I need to get a hold of a AlfaOBD devise?

 

[Brutal_HO]

I like what I'm hearing!! excuse mt ignorance here but how do i get that done? Sounds like I need to get a hold of a AlfaOBD devise?

AlfaOBD

Has anyone played with AlfaOBD on their 2019 HD's yet? I'm curious if anything is accessible to "change" and if it just works. There is lots of different info out there on other forums, but i haven't found anything in regards to the 2019's. EDIT: AlfaOBD does work, here is the what is needed...

hdrams.com

Got Android?

 

[AH64ID]

You will need AlfaOBD, or JScan, a security bypass cable, and a OBDII dongle.

These are what I have:

Amazon.com

Security Module Bypass | KaodTech

Will Ship 3-5 Business Days after OrderIf you have a 2018 - 2024 RAM and would like to perform diagnostics or make changes to the modules of your truck using tools like AlfaOBD or AutoEngenuity, this bypass is for you.Does this allow access to all modules?It has been tested connecting to the BCM...

www.kaodtech.com

 

[Smittys2500RAM]

Okay Thx!! Bummer I have all apple products. Guess I will need an android of some sort. I will start reading up on this, Thx Y'all!!!

 

[Jimmy07]

Okay Thx!! Bummer I have all apple products. Guess I will need an android of some sort. I will start reading up on this, Thx Y'all!!!

Use JScan instead then.

 

[Smittys2500RAM]

I mounted these o the closest to center bolts and angled them out a tad. I didn't like the look of them out so far and they work great here. Now to figure out how to wire them up to the AUX reverse switch....

 

[dieselscout80]

The extra light is great.

I would worry about smashing them when dragging the bumper.

As it is I worry about the sensors and that plastic trim.

 

[John Jensen]

I mounted these o the closest to center bolts and angled them out a tad. I didn't like the look of them out so far and they work great here. Now to figure out how to wire them up to the AUX reverse switch...

I did what you want. Here's how I did it.

 

[deanfx]

I deff like where you mounted yours. I put mine out one bolt further from the center. Hell I might change mine now ha