What's new
By:
Ram Heavy Duty Forum

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Blunt wires in rear. A500 and F606

Pond Brook

Pond Brook

New Member
Messages
4
Reaction score
0
Points
1
Location
Monkton, VT
I'm a little confused. From what I am seeing, I don't have aux switches. However the wiring is still there. I found them in the rear, just can't seem to find them up front. Did they change the color mid way going forward?
How do I get power to these wires?
2022 Laramie Sport 2500
 

Attachments

  • Dashboard.jpg
    Dashboard.jpg
    527.5 KB · Views: 19
Pond Brook said:
I'm a little confused. From what I am seeing, I don't have aux switches. However the wiring is still there. I found them in the rear, just can't seem to find them up front. Did they change the color mid way going forward?
How do I get power to these wires?
2022 Laramie Sport 2500
Click to expand...

How many wires did you find?

The wiring schematic just shows a CHMSL signal going to the rear without aux switches. It should be WH/VT.
 
Pond Brook said:
I'm a little confused. From what I am seeing, I don't have aux switches. However the wiring is still there. I found them in the rear, just can't seem to find them up front. Did they change the color mid way going forward?
How do I get power to these wires?
2022 Laramie Sport 2500
Click to expand...
The wires can still be there but they are dead ends (only in a short section of the harness back there) without the fitter switches. Somebody smarter will explain it better.
 
I have the two power wires back there too. I also found and already tapped into the CHMSL wire. That was in the same blunt wire bundle. I have the rd/wh and pk/og wires. Curious where they end. Are they any closer to power up front?
Figure if they are there, might as well tap into them and make them usable.
 
i also have the blank fitter switches up front under the dash. Although I can't seem to find the correct color wires coming in.
 
Pond Brook said:
I have the two power wires back there too. I also found and already tapped into the CHMSL wire. That was in the same blunt wire bundle. I have the rd/wh and pk/og wires. Curious where they end. Are they any closer to power up front?
Figure if they are there, might as well tap into them and make them usable.
Click to expand...

On the trucks with aux switches those terminate under the dash where a jumper gets plugged in.
 
AH64ID said:
On the trucks with aux switches those terminate under the dash where a jumper gets plugged in.
Click to expand...
I found the jumper plugs, however none of the colors of wires match up to printed schematics.
 
Pond Brook said:
I found the jumper plugs, however none of the colors of wires match up to printed schematics.
Click to expand...

Are you sure it’s the correct plug? There are multiple plugs under the dash.
 
You must log in or register to reply here.
Back
Top