Need help! Passive Entry Kit AlfaOBD settings

[cquilichini]

Hi guys,

I purchased a Passive Entry Kit from Nismopar and had it installed today. I only need to make changes to the truck programming via Alfaobd.

I was given the parameters to change. However I cannot seem to find where to change these parameters.

Can someone provide some guidance to where i can find the place in alfaobd where i can make the following changes?

VehConfig3 fobik safe enable- YES
VehConfig3 passive entry present- YES
Wireless AP1 Left front- SMART SWITCH
Wireless AP2 Right front- SMART SWITCH
LIN and Misc fobik safe alert no reply- YES
LIN and Misc fobik safe alert on system fault- YES
LIN and Misc fobik safe alert on search timeout- YES
LIN and Misc fobik safe alert per ignition cycle counter- 2
CustSetMenu 1 passive entry CSM present- YES
Cust.Prog.Features- Passive Entry Unlock All Doors or Approach Door- ENABLED

Thanks in advance guys!!!

Maybe @Jimmy07 can help? Thanks

 

[cquilichini]

The guys at Nismopar came through and helped via email. Thanks

 

[Brutal_HO]

For the benefit of others, BCM changes are done through Active Diagnostic, Car Configuration Change.

BACK UP YOUR CONFIG FIRST.