Obrracing
Member
So, 2500 is 7 months old, only about 2,700 miles on it (very short trip to work) and I noticed today a quick burp of blue smoke at start-up, just literally until the truck was running. Never noticed it before, but honestly I start it from inside the house most of the time, just happened to be walking right at it today. I have read where oil consumption is normal in the owner's manual during break in. I checked the oil, it still looks good from a color perspective and is just above the "add" arrow, so maybe could use a quart to get it halfway or more in the "XXXXXX" area. The pipe is pretty clean, maybe a bit of haze to it, but not much at all, like not wet w/oil or something.I did drive it a bit until it was warm and then rev'd it a few times and didn't see anything. Just wondering if it was something related to the Hemi and break in/residual whatever from a cold start, not letting it really warm up before shut off and then starting it again a few hours later. I do have the chirp everyone talks about, but chalked that up to normal based on all the forums and replies from folks.
Thanks for any help/thoughts...figured I would post here before the Gen Discussion to see if any die hard hemi engine SMEs monitor...
v/r Charlie
Thanks for any help/thoughts...figured I would post here before the Gen Discussion to see if any die hard hemi engine SMEs monitor...
v/r Charlie