2019 2500 Carli 3.25 Pintops front end shake

[AnthonyD1978]

Check the Carli website for tire pressures they recommend. I'm pretty sure its less than the 50 PSI you have in there now.

I'm running BFG 35's on stock 17" rims and run 40 front and 35 rear. She rides really nice.

I doubt Carli lists pressures for 22s. lol

 

[Rockcrawlindude]

I've had a camera under the truck driving and not seen it. I would be worried if there was. Even if there is some (maybe from the TC fluid turbulence) it should not be enough to shake the truck. I can spin my front drive shaft by hand when in 2wd.

^ it’s free in 2wd

 

[H3LZSN1P3R]

I've had a camera under the truck driving and not seen it. I would be worried if there was. Even if there is some (maybe from the TC fluid turbulence) it should not be enough to shake the truck. I can spin my front drive shaft by hand when in 2wd.

^ it’s free in 2wd

When in 2wd the CAD is disconnected but there can be residual spin from the opposing axle that goes to the left wheel, its not much and not everytruck will spin it but it does happen we used to see it all the time with the YJ’s and 2nd gen rams…. It wont spin enough to cause a shake though

 

[Rockcrawlindude]

The short side shaft spins the spider gears and they spin the disconnected stub shaft. Getting the driveshaft to stop spinning is the whole point of the disconnect.

 

[H3LZSN1P3R]

The short side shaft spins the spider gears and they spin the disconnected stub shaft. Getting the driveshaft to stop spinning is the whole point of the disconnect.

If there is any drag on the center link it will transfer the motion to the driveshaft