Search results

I'm in the process of adding fog lights to my Tradesman and I think I've read all the threads on the topic. I have everything I need except for the specific wire terminals that are required for the BCM connector. What is the specific part number or spec of the terminal that fits, and where is...

I'll use the black plastic dip on the chrome emblems, and already have black lug nuts to go on it. Then I'm probably done with the exterior.

I found a set of used power wagon rock sliders locally. I then bought original power wagon fender flares direct from dealer. These were actually the same price or cheaper than most of the after market ones I looked at.

I had the bottom of the truck wrapped to simulate the 2 tone paint on a power wagon

Power wagon wheels went on it with less than a 100 miles.

Iv'e been lurking here for awhile and finally got some results on my build. I wanted to order a truck but found a good deal on one that was close enough to my original desired specs to just buy it locally. I'm a diesel guy but I love the look of the power wagon. In order to get the black...

Doesn't traction control just apply the brake to the slipping wheel? I'd like both wheels to drive

I have a 2022 Tradesman 6.7 4x4 which unfortunately didn't get ordered with the LSD differential, and this thing will get stuck in a flat gravel parking lot if I don't put it in 4 wheel drive. I don't need an air locker or anything for extreme off road, just a functioning LSD. From the...

I've found the correct rivnuts for the 6 larger bolts that go into the back side of the rocker box. Can't see where the smaller (m6?) bolts go. Does anyone have pics or an exploded View?

I think it might.

I've used the round riv nuts with the serations, but haven't seen hex riv nuts.

I'm sure its been done, but didn't see it with a search. I see 6 hex shaped holes in the right place, but there is no plate nut attached to the truck body. Looks close to impossible to get a nut and washer into the body channel behind where the 6 holes are. Has anyone done this and know of a...

Are these still available?

Still available? I'm local

Thank you guys! I'm planning something of a Power wagon clone externally. Getting the lower part of the body wrapped in satin black vinyl next week. Then to find a reasonably priced set of OEM looking fender flares.

Guess I should add this with my first improvement and source of my first problem.

Hi all, new here and figured this is the best place to get advise on additions to my new truck. I've just replaced my trusty 1999 2500 diesel with 500,000 miles on it. Like an old dog, it was time to go. I do almost all mechanical work on my vehicles, but the electronic complexity of this...