Search results

for s/g's, did you make sure the lines are enabled in settings? If not, if you have Alfaobd you can check if the module has codes....And try looking at the settings: LIN Module Customer Programmable Features: Rear View Camera Dynamic Grid Lines Enabled: Set Vehicle Config Customer Settings...

As for your phone, RESET the cache on your wi-fi/bluetooth in settings.

They did just use a wrap or paint? I would think wrapping it is quicker..

I was also thinking of doing this and doing the upper half of the cab from the A-pillars to the back. But with it being this granite grey that you couldn't tell the difference..now after seeing your Pic, ill move forward with it.

DM Jimmy directly

Looking thick! So did you vgt or 2g swap it?

hah..you guys are getting too dependent on the technology...Think of the days when we didnt have back-up sensors OR cameras..we actually had to throw our right arm onto the seat and god forbid, look over our shoulders to reverse :p Yeah, when the camera gets wet or dirty...its screwed...

I have my rack still in the box..Magnum daisy chains there harness to the trailer plug. Hmm, I wonder if the problem is only with the '25 models.

Kinda a travesty for the welder since I have to heat wrap his artwork. Unless anyone knows if there's a coating to insulate the hot and down pipe

You can turn if off with AlphaOBD.. Try this (compliments of Jimmy007) I did this since I removed my drivers side step and left the passenger side intact and I was getting the EVIC warnings every few minutes. Disable CustSetMenu 2: Automatic Side Step CSM Present, CustSetMenu 3: Power Side Step...

Tweaked alignment a little ..but shes pretty much done...gotta re-tune later...dyno time getting a little expensive....gotta do some OT to help pay for it...hah

on the dyno for fine-tuning dyno time

heck, 2G swap it since its deleted :p (there's a few 2G swap kits I can rattle off...Point Zero Fab, Evil Fab, Philips Fab and WC Fab come to mind. The "most" complete kits if seen were Point Zero, they include everything down to the coolant re-routes. Other kits, you sometimes have to...

Piping coming along

So is 2Lo better than installing manual locking hubs and be run full-time in 2WD?

Sirius is NO longer supporting NAV and Traffic...You HAVE to use UCONNECT services to subscribe now. I think its called uconnect plus services.

With all these holiday specials going on, decided to add a S480 and 60 over sticks...can't wait for the piping to be welded up.

Dang it...now i have to spend more money on lights and the Morimoto brackets..

Cause its WAAAAAY more easier to just spend less than an hour to lift the cab and have full access around the engine. Have you ever removed the grill or the bumper and the entire frontend? All those bolts you gotta keep track of. Lifting the cab, its 4 bolts and unplugging come connectors..thats...

You might have to get them wrapped or re-sprayed..Here's a link I found a while back from Etsy that does gloss wraps https://tinyurl.com/4c87wce4