Recent content by xxr00fxx

There are 4 clips on the fuse box, it lifts straight up, but not far. The plug is held in place with some sort of plastic clip that I had pulled loose. Don’t remember if it was the type that slides in or if it was a barbed plastic type. Then unplug the harness and you have a small amount of...

it’s under the fuse box. One photo shows the (new) white wire going to ground post. Other wire shows my wire going down to the wire harness where it’s spliced. Too cold out (10) to get any better photos right now.

I just completed adding remote start on my 2024 Tradesman 2500 this morning. I used the bypass cable from infotainment, eBay key fob that was recommended by Jimmy07 in the 2020 mega thread, and a vLinker MC+ to connect with JScan. I do not have the wired hood latch. I cut and tied in a 1k ohm...

Anyone happen to have a wiring diagram for those plugs under rear seat? Looking at stealing 12v power for rear usb charging from there, but would like to know where wires come from before tying into the circuit. Bonus if anyone knows the matching plug part so I could make a harness. 2024 2500...