Recent content by timbo1083

I connect to Body Computer, MY2022+ PowerNet, and I get back “connected to body control module continental MY2020”. I head over to car configuration change. Model year I set to 2022. Get it to where it says : Current Status of Component: 22 I’ll try and calibrate tomorrow when the sun is back...

I believe 2022 components. I’m not sure on the bcm part. I’ll give it a go tomorrow. Jimmy has been super helpful too. I appreciate you both. Sent from my iPhone using Tapatalk

2020 3500 Sent from my iPhone using Tapatalk

I get two faults. B223B and B23C8. Sent from my iPhone using Tapatalk

I didn’t clear the code each time, because it doesn’t throw one. Not sure what I’m doing wrong. I did each camera one at a time. But it keeps saying no errors? Sent from my iPhone using Tapatalk

I have mine all working. Cameras go through calibration. It shows up 360 on the screen looks great. After a few seconds reverts to all black around the truck. Any ideas? Sent from my iPhone using Tapatalk

You have to source a 12” screen for UC5, source a used radio control module. And then a couple of cable harnesses. Right around $2k mark total. Then alpha odb some settings. That might have just been for the surround camera which if you have you need the newer control box under the seat. Sent...

Time and money honestly. There are a ton of posts where the parts needed (less if you already have 360 etc). Jimmy07 has a lot of write up’s. Sent from my iPhone using Tapatalk

I have a 2020 3500 with a UC5 swap. Can I do the digital mirror upgrade also? Sent from my iPhone using Tapatalk

Whelp. I don’t have the right connector. I’ll order it. And just putting it in there didn’t make a good enough connection [emoji28]. I’ll update after I get a new connector. Sent from my iPhone using Tapatalk

I have 56029965AC and 04672644AJ Sent from my iPhone using Tapatalk

I did. But I saw this as well. Happen to know which pin it goes into? I have new connectors to recrimp now. But where does it go? Sent from my iPhone using Tapatalk

Hey everyone! I tried to do some searching, but I could have easily missed it. I have a 2020 3500 with the 12" Screen (UC4) and upgraded to UC5. Everything is working great, minus Sat Radio which I haven't seen a fix for but doesn't bother me too much, as I don't use it much. However I also...