Recent content by StevenKuhn

I'm in the process of planning out a g56 swap on my 17 Power Wagon and looking at the fuel lines, they cross over the 66rfe right where the g56 shifter will go throughthe floor and will need to be moved. From the tank to just before they go over the trans, the lines look like plastic. Are they...

Right 4th gen for the clutch assembly and clutch hydraulics, shifter boots and stuff like that. All my current trim pieces will work just fine. I could get a cummins g56 but would have to change the bellhousing and input shaft. As far as the computer goes, there is literally an option in the...

What do you mean by provision? The 2500 and 3500 cabs are all the same. Only difference from what I can see is the actual hole in the floor for the shifter.

I have been looking into this recently for my 17 Power Wagon and have the mechanical side pretty much figured out as far as I can tell. 5.7 hemi flywheel and clutch, 5.7 g56 (for ease of installation, can use a cummins g56 by swap g bellhousing and input shaft) my bw 44-47 will bolt up no...