Recent content by silverheep

I’m trying to track down an issue similar to this - did the new BCM fix the issue?

FYI - my truck (‘24 PW lvl2) has the RVDM from the factory, and when I put a topper on and installed a long fakra cable to move the camera back to the topper, I occasionally get this error message. I’m guessing something to do with the resistance of the longer cable may be triggering it - but it...

Can’t hear a thing, and that was even before the Borla exhaust!

Do you remember what part you used, and did you have to run wheel spacers? Would love to put a set on my wife’s JL, because they’ve been great on my PW!

That’s a great question. I’ll check that in a couple hours and see what difference it makes!

My ‘24 does as well - perfect alignment, it’s 5/8”lower (front and rear) on the drivers side than the passenger side with the fuel gauge on E. I’ve been looking for a shim kit front and rear, and saw Thuren has one for the rear, but not the front. If anyone has any ideas, I’d be curious!

I’m looking at the Metalcloak vs the Thuren as well - which direction did you go with this?

Seconded

They mentioned it back in November when they announced their 3 bar replacement - I think what we are seeing is that there are only so many ways to create a skid for this area! The CJC skid is pretty similar to the SDHQ skid as well - same thing there, in my opinion.

They announced these before @MDethloff showed his design, and they are definitely different. Nice to have options here!

Love your build - it’s made me lean towards the SmartCap. Have you had any issues with leaking? I keep seeing people saying constantly and people saying never - so I’m guessing it has to do with assembly/fitment, would love your thoughts. Also - any issues with locks freezing shut? I’m in...

This looks incredible. I’m in as soon as orders are open.

Yep - this is exactly where I’m at as well.

They look good, and I’d hoped it would cover the plastic transmission pan, but the website description states “transfer case tail housing and upper driveshaft”. Too bad, I’d have ordered immediately.

@H3LZSN1P3R loosely based on your idea, I figured anything required for the engine running should work, ended up using a fuse tap at the F63 coil fuse, and it’s working like I’d hoped - on with both ignition and remote start. Edited to add - does not come on in the accessory position, but for...