Recent content by Sam 15

My 14 has 4 places

On my 2014 3500 the jam nuts were tacked welded, not welded all the way around as a permanate fix. I would assume most alignment I would not have the (simple equipment) to cut the tack welds with a cutoff wheel, perform the alignment and then tach weld the jam nuts again. Alternative solution...

AI Overview Learn more A "Ram welded tie rod" refers to a tie rod on a Dodge Ram truck, specifically from the 2013-2018 model years, where the adjusting nuts on the drag link assembly (part of the tie rod system) are welded to the adjuster sleeve as part of a safety recall, preventing them from...

There is an adjustment for the headlights. There are several you tube videos for this. Here are a couple. I just replaced the headlights on my 2012 camry. In a video for that it shows the proper way to adjust on the camry. Park on a level surface 25 feet away from a wall, measure to the...

DM sent

So....what was it?

Thanks for the reply Nick. Sounds like a winner for our weather.

2014 3500 srw 6.4. My trans temp has been fluctuating lately with no trailer load, in other words, empty. It will run normally at *168 and creep up into the *190's in the summer months. I'm in So. Cal where outside temps are +/- *115 right now. Climbing the grade up hwy 62 from the I10...

2014 3500 srw 6.4. My trans temp has been fluctuating lately with no trailer load, in other words, empty. It will run normally at *168 and creep up into the *190's in the summer months. I'm in So. Cal where outside temps are +/- *115 right now. Climbing the grade up hwy 62 from the I10...

My experiance is that the newer vehicles do not give you the slow crank warning of an impending battery failure...you come out one day and bam...dead battery. Buy one of the small battery jump starters and keep it in your vehicle(s). You can find them pretty reasonablely priced. As far as...

I'll throw this out there. Check your motor mounts. Open the hood. With truck in drive push hard on the brake, then push on the gas pedal. Watch the engine from between the bottom of the hood and the cowl. If the engine rises a lot (and it will be noticable) a motor mount is out. You should...

That's no suprise. If they can get away with telling you no on the buy back it saves them money. Just like an insurance company will tell you no on a claim. They hope you accept their answer and go away. Continueing to have warranty work done is cheaper that a buy back (in other words lemon...

Great follow-up. Thanks

Welcome to the forum.

Wait a second....I need to get my glasses