Recent content by roybell

Has ram updated the ACC and Lane Assist on HD Rams yet? I have a 2021 with an Aisin and I made the mistake of test driving a 2025 with the new 8 speed trans. That thing rips compared to my lazy 2021. I didn't get a chance to check the adaptive features. Is it the same as the 2021 and older...

Does anyone make wheel-to-wheel steps for a '24 regular cab AND bed access? The only one I can find are N-Fab for 2002-2009 trucks. https://www.summitracing.com/parts/nfb-d0284rc-4-tx

I don't have the hood latch, but will be buying one. I followed the instructions in this POST by Jimmy. The Gray harness plug is under the fuse box in the engine bay. I found the wire from Pin 9. I cut it, soldered on a 1K resistor, extended a wire from the end of the resistor and grounded it...

Yes. This was on a 2024 2500 Tradesman. My 3500 Limited came with it from the factory. We are now going to try it on one of my guys 1500 Classic.

Got it to work on my 2024 Tradesman. Found the purple wire in the gray harness under the hood. I had to ground with 1K resistor. I tried without it and the 500ohm setting and it showed hood ajar. Changed to 1K and it showed closed with the resistor. I am going to order the hood switch and...

My 2024 2500 has both blocks Green with white connectors. I put the white connector on the back block, and the black connector on the front block and it all works. Of course first time I had it reversed and the OBD port wouldn't read the car. I flipped them and it worked fine then.

Is there a list of available functions from AlfaOBD? I have a '21 3500 with rear air assist. I'd like to be able to lower the weight threshold for ALT RIDE HEIGHT. Truck rides entirely way too stiff with an empty bed. Once, after unhooking a trailer, it stayed in Alt Height without the...

Pulled everything apart and there is no cable existing. Ordered the resistor to ground out the pin vs running a new wire to the cab. Was able to get the new ebay key programmed using JScan. There is an option to turn remote start on from that app too. I enabled it. It tries to start...

I'll have to pull it in the garage tomorrow and pull the plastics to see if there's a pigtail existing. I did not see anything out in the open. Sweet, thanks.

Is the existing wiring under hood for the OEM ajar switch? I can buy the latch for $45 which has the ajar switch. Just not sure if the plug is existing for connecting to the ajar switch. Rather not start cutting and soldering resisters on a business vehicle with 200 miles on it. I ordered...

Is this the same process for a 2024 Tradesman? Just picked up a new shop truck and was looking into the tailgate dampener when I found I could enable the buttons, and add remote start. Pretty slick. I'll have to see if it has the hood switch. My '21 Limited has remote start so I assume it...