Recent content by Ramster3000

My truck came with the factory trailer cam Any idea on where to get the 3d printed camera setup? If I was going to do it I like the sleek design of some of the ones posted in here. Unfortunately I decided to not rob the connection from the trailer port on the bumper because im going to use...

I would imagine it’s the same as far as the wires go. It’s basically the same truck. Footprint wise. I did find out when messing with it I can use a split screen view of the side mirrors shooting backwards that shows up on the rear view mirror. It’s almost identical to the actual rear view cam...

Sent a message to @kpecks but looks like he hasn’t been on since NOV. I have a 24’ loaded Laramie 3500 With ARE cap. Id like to gain the digi rear cam back. I was initially thinking id want to just steal the wired tow mode cam cable from under the bumper BUT im thinking I need to use that for...

Update! Got the NH Overland bracket with pre term kit mounted and wire ran into cab. For those of you with a plow on your truck ….. this kit will fit (at least with a Boss plow config). It was TIGHT. If I had to do it all over again It prob would have been better to do the other mount closer to...

Getting ready to do my install. I have extra fuse taps. Looks like I’ll be able to follow the Same path you did. Im doing the @NHOverland sunglasses mount and fuse panel mount. So far im doing : plow switch baja 20” ONX6+ amber in bumper cut out Pillar mount BD LP4 pro amber Baja S2...

I was having a hard time seeing what the cover plate looked like on the term. Im not overly concerned about water but it looks like short of blasting with a hose it should be water resistant enough? I ended up getting it , then this site was down lol

About ready to pull the pin and order the NH overland switch pros mount , and sunglass switch mount. https://www.nhoverland.com/products/copy-of-19-ram-hd-fuse-box-pre-wired-switch-pro-sp-9100-mount?variant=42080282837176

Sort of…. Page 195 of the current 24’ manual. Very general it says 3500 , 23,000lb on the hitch 37,100 on the gooseneck. I know that is not correct for my truck. It also says go to rambodybuilder.com which no longer exists….

I did some searching off forum and on forum. I found the VIN look up tool. 24’ 3500 laramie CC 6‘4” box. “Loaded“ night edition. Missing air bags, sunroof. (Custom order) says max payload 3,616 and max towing 23,096 assuming the max towing is goose/fifth wheel? Im a bumper pull only and...

I would get a gasser. I had an 18’ diesel 3500. Not a daily. Low miles and emissions probs. Swapped to an ordered 2500 gasser. Business needs changed and ended up towing 14k lbs a few times locally with my excavator and that made me order another 3500 diesel. With that said , as a business owner...

I use a boss plow. Im not a plow company. I just had It swapped from my 22’ 2500 to my 24’ 3500. It’s an awesome shop near me. Im particular and feel like they do a better job than I could because they’ve done so many. From talking to them the ram is one of the easier ones I believe , with plug...

Hey guys, new here but not new to forum life. I wish I would have joined before I built and recieved my 24’ 3500 laramie loaded night edition. Sadly I ended up with the trailer control instead of My aux switches… ugh. (I thought i was safe because i was coming from a 22’ loaded laramie gasser...