Ram Heavy Duty Forum

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Recent content by MrDad36

  1. M

    No crank no start

    It really was as simple as that. Took me quite a while to figure it out
  2. M

    Transmission fluid change

    My truck is not under warranty so I’ve never been worried about that. I’m sure you read the previous comments on this thread of My concerns doing it myself. I did in fact do it myself and it was very straightforward. I contacted the transmission manufacturer and if I remember correctly they...
  3. M

    Transmission fluid change

    Hmm. I’ll have to research this again because I googled it and thought I saw it was supposed to be done every 60k miles. I found a place online who sells the pan (with filter built in it obviously) and 5 quarts. They have a side note that mentions 3 quarts (or liters?) remain in the...
  4. M

    Transmission fluid change

    122k. I don’t know if it was done at the 60k interval it probably not. I bought it with 80k miles. I tow 10k lbs often
  5. M

    Transmission fluid change

    Hi everyone. I’m looking to do a transmission fluid change on my 2019 bighorn 6.4liter 8 speed transmission. I need to replace the pan on this style. Does anyone have a good recommendation as to what fluid to use, where to get it from? Same with the pan. Also, am I just going to let the...
  6. M

    No crank no start

    How hard was replacing it? Any crazy extensions / swivel knuckles needed? I can’t find any videos on a 2019 2500 starter swap. I’m not sure what years it’s comparable to. I think they changed a lot from 2009-2018 styles?
  7. M

    No crank no start

    That’s still a thing? Thanks
  8. M

    No crank no start

    Hi everyone, seeing if someone can educate me here. I have a 2019 2500 6.4 bighorn. Now, I also have a new battery. Long story short, I very randomly get a no crank no start, sometimes 2,3, and even 4 times in a row before the truck finally turns over and starts. There’s about a 10 second pause...
  9. M

    Parasitic draw / control module issue?

    That’s a god thought. It’s going to be pretty tough for me to do by myself, I’m pretty sure the negative cable slides down pretty far on the post. So long as I can get a meter lead on the very bottom of the negative post to be able to slip the cable off, this would be a good check to accomplish...
  10. M

    Parasitic draw / control module issue?

    I’ll check the fuses tomorrow just to be able to say I did. What ground connections would I be checking? The connections on the main lug? And the main lug connection itself? No, I can’t say I checked they were tight, but didn’t appear to be loose. I have not inspected wiring for signals of...
  11. M

    Parasitic draw / control module issue?

    Slow moving process here everyone. Still can’t find an issue causing the battery to die. It wouldn’t start for me today, took 4 try’s for it to even decide to turn the engine over, to which it started. I verified a 3 amp draw that dies down to about 300 milliamps within a minute. I found a...
  12. M

    Parasitic draw / control module issue?

    Thanks for the input. I’ve noticed the lack of quality with anything Ram. I don’t think that even a better quality battery would hold you long term with this intermittent draw, at least not in my off season when I only drive the truck a few times a week, which wouldn’t let the battery get...
  13. M

    Parasitic draw / control module issue?

    I’ll try that tomorrow. FYI, the other day, with the fob on me, the truck woke up three times in a row about 2-5 minutes apart. Tonight, it only woke up once… same procedure. I’ll give some feedback with what it does tomorrow with the fob in the house.
  14. M

    Parasitic draw / control module issue?

    You are correct, I can do that to find the parasitic draw. I got hung up trying to see what the milliamp draw overall was before doing that though. I thought I had the problem with the bottom glove box light, but now I’m realizing the light would shut off once the truck goes to sleep, so that...
  15. M

    Parasitic draw / control module issue?

    I’m ready to find a nice cliff to roll this thing off of
Back
Top