Recent content by LateToTheParty

Sounds like you need to hop under the front end and adjust the drag link a bit. Based on the picture above, I'd guess 3-4 rotations toward the rear of the truck would get it just about centered.

From the pics I agree with the thought above that it looks very light in front. If you are guessing at what the tongue weight is, I would recommend either taking it to a scale or buying one of those jacks that allow you to truly measure the tongue weight. If those numbers have actually been...

Sunglasses and chewing gum.

Precisely what I use. It has worked great for 20' trex and boxes of 20' vinyl siding. But as mentioned above, it does make for some wide turns

I had the Undercover brand in my 4th gen for a while, but after bouncing it around a couple of hunting seasons the plastic broke to the point it was no longer usable. I then removed and repurposed the hinge and latch hardware to mount a surplus ammo can in the same manor. Neither consumed any...

It sounds to me like someone set a memory profile either by accident or as a prank. If you have an owner's manual, you should be able to find it under To create a new memory profile, perform the following: Note: Saving a new memory profile will erase the selected profile from memory. Place...

https://ikonicbadges.com/collections/2019-ram%C2%AE-replacement-badges

Agreed. But OP's first option mentioned putting it in front of the MBRP, as well as the options pre/post axle but behind the MBRP.

I just dealt with it until it rusted out and fell apart, then replaced with a Borla setup. That said, since the drone from the muffler is what you're hoping to remove, I don't know that adding the resonator before it would be the answer, as it would eliminate some frequencies from the engine...

Sounds to me like your starter is on its last leg. The symptoms and situation you describe sounds exactly like when mine gave out. That was at around 35k miles and the truck was just under 3 years old at the time.

I've experienced similar on my 12" screen 3 or 4 times over the last 4 years, however if I recall correctly, mine stayed off each time until I stopped and restarted the truck. It has been so infrequent and since I could never reproduce, I just chalked it up to being a covid truck (also a 2020).

That's twice the life I got out of my starter. Unfortunately mine happened at work, so let the dealer take care of it while it was still under warranty.

I would also try recalibrating if you haven't already. There should be an option somewhere in the nav settings and while doing it I believe you have to drive in a few circles and figure 8 patterns in an open field/lot.

Yes, it is. I did it to my 2016 Tradesman with that same basic rear bench. Process was exactly the same as doing it to my 2020 Laramie split bench.

No, those are not aux switches. Here's a good thread if you really wanted to go through the effort to add them. https://hdrams.com/forum/index.php?threads/diy-add-aux-switches-to-19-ram-2500-laramie-6-7l.13229/