Recent content by kkerley

I would put some weight to the possibility of a ground issue or something similar. I had very rough starts a few months ago, like the starter was going out. Battery had been replaced a few months prior so I assumed it was not the battery. I tightened the connections to the starter motor and no...

Added running board lighting, I always like more lights but not cutting/splicing/tapping factory wires. I have some OPT7 lights on an older car and have been happy with them so went with OPT7 Sidekick 60" Running Board Lights. These lights provide white courtesy lights when doors are opened...

Happens 75% of start ups for about the last week, annoying more than anything!

I had mine stop "working" with the remote also. It would make noise but not lock or unlock the rambox, had to use the key. There are connectors holding rods that actuate the locking mechanism, one of those connectors broke. Maybe check that, I don't remember where but I found a post about it...

Stock suspension or modified? Any rubbing? This is my next change just can't decide which size. Thanks

no idea, mine came with the mopar bed lights installed so the switch was already present, you may want to look up someone who didn't have the kit already and added the mopar kit and what they had to do for a switch

I can add it up on my sweet calculator

if you will weigh each part we may be able to see

what did you have to do to enable the cameras with blinker function?

PPD? I'm in Paducah.

I don't like making extra holes so I used one of the existing mounting screws in the rambox and mounted a buckeye 13315 with included vehicle bracket.

was the wrap failure user error or short comings of the wrap? I am not trying to insult your wrapping ability only asking because I have considered doing the same in case I wanted to return to chrome.

not at this time, there are no work arounds that i have seen to enable any of the cameras other than those shown in the rear view mirror while at normal driving speeds other than for a few seconds at a time

I am getting mine done next Friday, 70 on windshield, back doors and back glass. Going back and forth between 20 or 30 for front doors, installer said 20 to match factory, but I don’t want too dark to make backing an issue, towing gooseneck and I back into the garage due to driveway angle...

sticker shield