Ram Heavy Duty Forum

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Recent content by Hecmn

  1. H

    Engine Light on After Cold Start

    I have read on this and other forums where many people have good things to say about the Walmart AGMs. Has me curious. Before running to Costco I will do a cost compare at our local Walmart.
  2. H

    Engine Light on After Cold Start

    I'm leaning towards Costco Interstates for replacements. As you said, hard to argue with the price and warranty. Had new tires put on last spring at Costco - they are 1 hour away in Duluth, but were about $600 lower than a local business. Try to go local as much as possible, but .... $600. You...
  3. H

    Engine Light on After Cold Start

    Interesting that the 3-minute note is in some model year manuals and not others. I drive it frequently spring through fall. Somewhat parked in the winter months otherwise with how much road salt is used in MN I would have a diesel engine with no truck body/frame. In the winter I will run it...
  4. H

    Engine Light on After Cold Start

    I've attached pages 37 and 38 from my 2019 Diesel Supplement manual. Page 37 shows what I mentioned on the 3-minute idle time and page 38 shows what you stated about the heaters shutting off after hitting a certain speed. I'm in northern MN and in the mornings the heat cycle will come on the...
  5. H

    Engine Light on After Cold Start

    Three codes registered. All the same P0562 - System Voltage Low. The first code indicated 'Confirmed', the second 'Pending' and the third 'Permanent'. With engine running, the dash did not have the Battery Saver On/Low Voltage warning, just the check engine light. Batteries are original - 6...
  6. H

    Engine Light on After Cold Start

    Agree on idle time, and normally I am minimizing idle time. Got caught up with some snow clearing and idled it longer than typical. The manual does say to idle about 3 minutes to allow the heaters to complete the post-heat cycle along with avoiding continual operation when the coolant temp is...
  7. H

    Engine Light on After Cold Start

    Trash Panda - thanks for the reply. Just out of curiosity, what other parameters do you keep tabs on?
  8. H

    Engine Light on After Cold Start

    I realize this is a wide-open question given the fact that you can spend less than $100 or several hundred dollars on one, but any recommendations on an OBD2 scanner? Rule of tools - when you need one, buy it.
  9. H

    Engine Light on After Cold Start

    Noticed engine light was on after cold starting (block heater had been plugged in for 2+ hours) and idling for about 15 minutes. Temp was -20F, DEF tank 3/4 full, fuel just above 1/4 tank. Will the engine light come on if fuel gelled and plugged filters? Moved it into garage at 40F for about 30...
  10. H

    2022 Ram Tow/Trailer Camera Options

    Looking for some confirmation/suggestions on the camera/trailing options for building a 2022 3500 Laramie. We have a Jayco Talon 335T toy hauler that is prewired for a rear camera and cargo camera. This thread has a lot of info and based on that I am looking at building with the following...
  11. H

    Airbags

    Thanks - I would appreciate that.
  12. H

    Airbags

    If you are talking about right behind the cab mounting bracket that does look it would have been a good spot, but I have the rear seat in floor storage tubs that blocks that spot. I was considering just in front of that same cab bracket, but there is a wire bundle running along the top of the...
  13. H

    Airbags

    Where did you end up installing the 7400EZ? I have the 5000 Ultimate plus bags installed, but I'm not seeing a great location for the 7400EZ. Thanks,
  14. H

    Airbags

    Looking at installing the Airlift 500 Ultimate air bags like BGaero only with the wireless compressor on a 2019 2500 shortbed with Cummins 6.7. Wondering about compressor mounting locations? Thanks
Back
Top