Recent content by Blackfin

I run 295/60/20 Toyo AT3 on my 2500 which has the air suspension. I tow an 11,000 pound center console with no issues, no rubbing. Very happy with tires and they look great on the truck.

Painted mine with high temp primer and paint. Very easy job. Has held up well so far, 6 months in.

No issues with the sensors. I don't even turn them off.

Using a weigh-safe, think it is an 8" drop which is more than I need as you can see below, thing is a work of art. Sway control isn't really a thing for boats, some of the TT guys would be better to answer that one.

Hauled this around the southeast this summer and fall, about 2,000 miles in total and averaged around 9 mpg. Was a little concerned about having an open diff and pulling over 10k pounds up a slippery ramp (didn't have much choice of options back in May when I purchased) but surprisingly no...

Good eye, what do you want to know? Love the car, have owned it for the last 7 years. 1995 M3 with about 80k on it.

I never drove the truck on stock Firestones so can't answer. From my perspective the AT3s are quiet, only time I have noticed some tire noise is down in Florida on the concrete interstate sections it seemed to make a slight hum. Wasn't loud enough for the wife to notice if that tells you...

Love both the blues! Is that Cobalt on the 996? Cool to see another Porsche owner on the board, welcome!

I had the same question for my 2500, as a point of reference here are the measurements to the bottom of the hitch receiver opening: Standard = 20.6" Alt Trailer Height = 19.6" Bed Lowering Mode = 18.0" These were measured with no payload since it is a 2500. The bed lowering mode drops the...

I am running the Toyo Open Country AT3 in 295/60/20 on a stock truck. No rubbing, at least a finger width between tire and any interference.

Couple of options to consider: 1. Turn the vehicle in early. You will still be liable for the remaining payments but at least you won't have to pay the insurance on an unused vehicle. 2. Some manufacturers have "pull-ahead" programs that allow you to turn in the lease up to 6 months early and...

Thanks! I was surprised how easy it was to do. Not sure how well it will hold up, saw mixed experiences from other posts. Will try to post back in a few months with an update. With all of the outstanding attention to detail Ram puts on these trucks, especially the interior, it just seems like...

dfafd I totally disagree. I worked at two OEMs for over 15 years and can tell you this is not universally the case. It completely depends on the incentive strategy of the OEM, the way they manage customer lifecycle, and your specific usage needs of the vehicle. Many OEMs prefer leases as it...

Painted the exhaust black, used high-temp Rust-Oleum paint and primer. Easy job and hides the cheap looking factory pipe.

Looks great! Should be a factory option, I would have specced it on my Longhorn. Looks like you painted the Ram letters on the grill, do you have to remove the grill to get those off?